NALLATECH

http://www.nallatech.com/index.php/Intel-Xeon-FSB-Socket-Fillers/fsb-compute-module.html

http://www.nallatech.com/

Project Goals

- Implement a setup a LEON3 processor running Linux on the Nallatech board

- Set up Hasim environment

Project Status

- LEON3 is booting from Onchip RAM, and sending data through the FSB.

- Hasim is installed, waiting for the Bluespec license

Next steps

- Connect Chipscope to debug FPGA

- Make LEON3 boot from System main memory. That includes to connect the system bus directly to the FSB and write a bootloader.

 The measured speed is around 64-bytes 500.000 ACP_Memcopy() operations per second. 
 Since the LEON works at 100Mhz (100millions cycles per second) that not enough to support system bus.
 It will be neccesary to use big caches and tranfer data in bursts.

- Setup on-board DDR-II memory

Hints to work with Nallatech System

- The only way to communicate with the system right now is through the AFU interface, using the ACP_Memcopy() function.

 - Never use less than 64bytes to send and 64bytes to receive or the system will hang up.!!!
 
 - In the FPGA design you should always send back the number of bytes you declare in the ACP_Memcopy(), if not the system will hang.
 
 - The data is received and send to the FPGA in packets of 256 bits => 32 bytes. That means that each time you make a ACP_Memcopy() you will
   receive two packets (two rx_valid) and you must send two packets back, (two tx_valid).